CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL UNION |
Remove the union from the bank 1 cylinder head (front side) and bank 2 cylinder head (intake port side).

| *A | Front Side of RH | *B | Intake Side of LH |
Apply adhesive to 2 or 3 threads of the bolt ends of new unions.
Using a 12 mm deep socket wrench, install the 2 unions.
| 2. INSTALL STUD BOLT |
Using E6 and E8 "TORX" sockets, install the stud bolts.

| *A | Intake Side of RH | *B | Intake Side of LH |
| *C | Exhaust Side of RH | *D | Exhaust Side of LH |
| *E | Rear Side of RH | *F | Rear Side of LH |
| 3. INSTALL NO. 2 STRAIGHT SCREW PLUG |
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 No. 2 straight screw plugs.
| 4. INSTALL NO. 1 STRAIGHT SCREW PLUG |
Using a 10 mm hexagon wrench, install 4 new gaskets and the 4 No. 1 straight screw plugs.
| 5. INSTALL VALVE SPRING SEAT |
Install the valve spring seats to the cylinder head.
| 6. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to new valve stem oil seals.
| *A | Intake Side |
| *B | Exhaust Side |
| *1 | Gray |
| *2 | Black |
![]() |
Using SST, push in the oil seals.
| *a | CORRECT |
| *b | INCORRECT |
| 7. INSTALL INTAKE VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the intake valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the intake valve, inner compression spring and valve spring retainer to the cylinder head.
![]() |
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
| 8. INSTALL EXHAUST VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the exhaust valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the exhaust valve, inner compression spring and valve spring retainer to the cylinder head.
![]() |
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.