DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC No. | Monitoring Item | Malfunction Detection Condition | Trouble Area | Detection Timing | Detection Logic |
| P2610 | Soak timer (built into ECM) | There is an ECM internal malfunction (2 trip detection logic). | ECM | Engine running | 2 trip |

| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 minutes: Timer malfunction Within 9.5 hours: Timer start-up malfunction |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTC not stored | None |
| Ignition switch | ON |
| Engine | Running |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Monitor runs whenever following DTC not stored | None |
| Elapsed time from engine stop | Less than 1800 seconds |
| Ignition switch | ON |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Monitor runs whenever following DTC not stored | None |
| Elapsed time from engine stop | 2400 seconds or more |
| Ignition switch | ON |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Internal engine off timer (elapsed time from engine start) | Less than 7 minutes, or more than 13 minutes |
| ECM has a record of being started by soak timer | Yes |
| ECM has a record of being started by soak timer | No |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (Click here).
Start the engine and wait for 10 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
If no pending DTC is output, the repair has been successfully completed.
| NEXT | ||
| ||