Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (for Manual Seat)


    B356559E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-3 (LSP+) - B-1
    Always
    Below 1 Ω
    A-4 (LSP-) - B-2
    Always
    Below 1 Ω

    If the result is not as specified, replace the front seat inner belt assembly LH.
    Text in Illustration 
    *1
    Connector A
    *2
    Connector B
    *a
    Component without harness connected
    (Front Seat Inner Belt Assembly LH)



2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (for Power Seat)


    B356559E02
  1. for 8 Way Seat Type:
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-3 (LSP+) - B-1
    Always
    Below 1 Ω
    A-4 (LSP-) - B-2
    Always
    Below 1 Ω

    If the result is not as specified, replace the front seat inner belt assembly LH.
    Text in Illustration 
    *1
    Connector A
    *2
    Connector B
    *a
    Component without harness connected
    (Front Seat Inner Belt Assembly LH)



    B356559E03
  1. for 10 Way Seat Type:
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-3 (LSP+) - B-1
    Always
    Below 1 Ω
    A-4 (LSP-) - B-2
    Always
    Below 1 Ω
    A-5 (RDC) - A-6 (E)
    Seat belt unfastened
    Below 1 Ω
    A-5 (RDC) - A-6 (E)
    Seat belt fastened
    10 kΩ or higher

    If the result is not as specified, replace the front seat inner belt assembly LH.
    Text in Illustration 
    *1
    Connector A
    *2
    Connector B
    *a
    Component without harness connected
    (Front Seat Inner Belt Assembly LH)



3. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
  1. Connect the battery and an ammeter to the front seat inner belt assembly RH connector.



    B356560E02
  1. Measure the current according to the value(s) in the table below.

    Standard Current:
    Tester Connection
    Condition
    Specified Condition
    1 (RBE+) - 2 (RBE-)
    Battery voltage is 12V
    Seat belt unfastened
    4.0 to 7.0 mA
    1 (RBE+) - 2 (RBE-)
    Battery voltage is 12V
    Seat belt fastened
    12 to 18 mA

    If the result is not as specified, replace the front seat inner belt assembly RH.
    Text in Illustration 
    *a
    Component without harness connected
    (Front Seat Inner Belt Assembly RH)