OUTER REAR VIEW MIRROR > INSTALLATION |
| 1. INSTALL OUTER MIRROR COVER LH (for Extended Type) |
![]() |
Attach the 2 claws to install the outer mirror cover LH.
| 2. INSTALL SIDE TURN SIGNAL LIGHT LENS (for Extended Type) |
| 3. INSTALL OUTER MIRROR COVER (for Standard) |
![]() |
Attach the 3 claws labeled B.
Attach the 4 claws labeled A to install the outer mirror cover.
| 4. INSTALL OUTER MIRROR LIGHT ASSEMBLY LH (for Standard) |
Attach the 2 claws to install the outer mirror light assembly LH.
Connect the 2 connectors.
| 5. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY |
![]() |
w/ Mirror Heater:
Connect the 2 connectors.
![]() |
w/ Retract Mirror:
Connect the 3 connectors.
![]() |
w/ Blind Spot Monitor:
Connect the 3 connectors.
![]() |
Attach the 4 claws to install the outer rear view mirror sub-assembly LH.
| 6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Temporarily install the outer rear view mirror assembly by inserting the claw on the outer rear view mirror assembly into the holes on the vehicle.
Tighten the 3 nuts in the sequence shown in the illustration to install the outer rear view mirror assembly.
w/ Power Mirror Control System:
Connect the connector labeled A.
| 7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the 2 cables to the inside handle.
Attach the inside handle's knob to the door trim board.
Attach the 10 clips to install the door trim board.
![]() |
Install the inside handle and door trim board to the door trim panel with the screw.
Install the door trim board to the door panel with the screw.
Attach the clip.
| 8. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH |
![]() |
Attach the 3 clips to install the front lower door frame bracket garnish.
| 9. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
![]() |
Install the plate and regulator handle with the snap ring.
| 10. INSTALL FRONT UPPER ARMREST BASE PANEL LH |
Connect the master switch connector.
![]() |
Attach the 2 clips and 5 claws to install the front upper armrest base panel LH.
| *A | for Regular Cab |
| *B | for Double Cab, for CrewMax |
| 11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Attach the 4 claws to install the bezel plug.