Home › BODY ELECTRICAL › LIGHTING › DOOR MIRROR FOOT LIGHT

DOOR MIRROR FOOT LIGHT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH
  1. Push the upper part of the mirror surface and tilt it.



    B167982E01
  1. Using moulding remover D, push the bottom of the outer rear view mirror sub-assembly LH upwards as shown in the illustration. Slide the outer rear view mirror sub-assembly LH upwards to detach the 4 claws, and then remove the outer rear view mirror sub-assembly LH.
    Text in Illustration 
    *1
    Moulding Remover D
    *2
    Protective Tape

    HINT:
    Apply protective tape to the outer rear view mirror assembly LH to prevent it from being damaged.



    B167460
  1. w/ Mirror Heater:
    Disconnect the 2 connectors and remove the outer rear view mirror sub-assembly LH.



    B167461
  1. w/ Retract Mirror:
    Disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.



    B355995E01
  1. w/ Blind Spot Monitor:
    Using a screwdriver, disconnect the 3 connectors and remove the outer rear view mirror sub-assembly LH.
    Text in Illustration 
    *1
    Protective Tape



2. REMOVE OUTER MIRROR LIGHT ASSEMBLY LH


E139768
  1. Disconnect the 2 connectors.

  1. Detach the 2 claws and remove the outer mirror light assembly LH.