DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0711 | One of the following conditions (A), (B) or (C) is met: (A) (a), (b) and (c) are detected: (2-trip detection logic)
| Transmission wire (No. 1 ATF temperature sensor) |
| Related DTCs | P0711: ATF temperature sensor/Rationality check |
| Required sensors/Components | ATF temperature sensor |
| Frequency of operation | Continuous |
| Duration | Condition (A), (B), (C) and (D): 3 seconds Condition (E): Continuous |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | P0712, P0713, P2740, P2742, P2743 (ATF temperature sensor "A" circuit) P0115, P0116, P0117, P0118, P011B (ECT (Engine Coolant Temperature) sensor circuit) P0110, P0111, P0112, P0113 (IAT (Intake air temperature) sensor circuit) U0100 (CAN communication system) P2610 (Soak timer circuit) |
| Duration time from engine start | 12 seconds or more |
| ECT | -15°C (5°F) or higher |
| Permission flag for ATF temperature rationality check | ON |
| Time after engine start except for continuing shift position "N" or "P"*2 | 5 minutes or more |
| Accumulated driving time*1 | 75 seconds or more |
| Driving distance after engine start*3 | 4.7 km (3.0 miles) or more |
| ECT (12 seconds after engine start) | 15°C (59°F) or higher |
| IAT*4 | 15°C (59°F) or higher |
| Soak time | 5 hours or more |
| Duration time from engine start | 12 seconds or more |
| ECT | -15°C (5°F) or higher |
| Permission flag for ATF temperature rationality check | ON |
| Time after engine start except for continuing shift position "N" or "P"*2 | 21 minutes and 40 seconds or more |
| Accumulated driving time*1 | 140 seconds or more |
| Driving distance after engine start*3 | 9.0 km (5.6 miles) or more |
| ECT (12 seconds after engine start) | -10°C (14°F) or higher |
| IAT*4 | -10°C (14°F) or higher |
| Duration time from engine start | 12 seconds or more |
| ECT | -15°C (5°F) or higher |
| Permission flag for ATF temperature rationality check | ON |
| Time after engine start except for continuing shift position "N" or "P"*2 | 30 minutes or more |
| Accumulated driving time*1 | 400 seconds or more |
| Driving distance after engine start*3 | 16.0 km (9.9 miles) or more |
| ECT (12 seconds after engine start) | -15°C (5°F) or higher |
| IAT*4 | -15°C (5°F) or higher |
| Duration time from engine start | 12 seconds or more |
| ECT | -15°C (5°F) or higher |
| Permission flag for ATF temperature rationality check | ON |
| Time after engine start except for continuing shift position "N" or "P"*2 | 55 minutes or more |
| Accumulated driving time*1 | 750 seconds or more |
| Driving distance after engine start*3 | 27.0 km (16.8 miles) or more |
| Duration time for ECT to reach 60°C (140°F) | 10 seconds or more |
| ATF temperature (12 seconds after engine start) | 110°C (230°F) or higher |
| ECT (12 seconds after engine start) | Below 35°C (95°F) |
| Engine speed - Turbine speed | 50 rpm or more |
| Output speed | 400 rpm or more |
| Throttle valve opening angle | 5.5% or more |
| Shift position | Not "N" or "P" |
| Engine | Starting |
| However, accumulated driving time is cleared | - |
| When following condition met | - |
| Duration time from shift position "N" or "P" | 300 seconds or more |
| Duration time from shift position "N" or "P" | 300 seconds or more |
| Duration time from shift position "N" or "P" | 300 seconds or more |
| 12 sec. after engine start | - |
| Duration time from shift position "N" or "P" | 300 seconds or more |
| ATF temperature | Below 20°C (68°F) |
| ATF temperature | 110°C (230°F) or higher |
| ATF temperature | 20°C (68°F) or higher |
| ATF temperature | Below 110°C (230°F) |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | No. 1 ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If the value is -40°C (-40°F) or 215°C (419°F), the No. 1 ATF temperature sensor circuit is open or shorted. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0711) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||