DTC P0604 Internal Control Module Random Access Memory (RAM) Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0604 | There is an ECM internal error (1 trip detection logic). | ECM |
| Related DTCs | P0604: ECM RAM error |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 6 times |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | None |
| RAM mirror check | Fail |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK WHETHER DTC OUTPUT RECURS (P0604) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P0604 is output | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||