POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > FAIL-SAFE CHART |
| POWER WINDOW OPERATION IN FAIL-SAFE MODE |
The power window control system prohibits the following power window operation when the pulse sensor for the jam protection function has problems and the window position or the learned value is abnormal.
| Power Window Operation | Ignition Switch ON | Key-Off (Within Approximately 45 Seconds after Ignition Switch Turned Off) | Key-Off (After Approximately 45 Seconds Elapsed after Ignition Switch Turned Off) |
| Manual UP | Operation prohibited | Operation prohibited | Operation prohibited |
| Manual DOWN | Operative (Jam protection not operative) | Operation prohibited | Operation prohibited |
| AUTO UP (hold switch at AUTO UP position) | Operative (in MANUAL mode) (Jam protection not operative) | Operation prohibited | Operation prohibited |
| AUTO UP | Operation prohibited | Operation prohibited | Operation prohibited |
| AUTO DOWN | Operation prohibited | Operation prohibited | Operation prohibited |
If the LIN communication line malfunctions (communication stop), the power window control system prohibits the following operations.
| Power Window Operation | Ignition Switch ON |
| MANUAL UP | Operative (Jam protection operative) |
| MANUAL DOWN | Operative (Jam protection not operative) |
| AUTO UP (hold switch at AUTO UP position) | - |
| AUTO UP | - |
| AUTO DOWN | - |
| Power Window Operation | Ignition Switch ON |
| MANUAL UP | Operative (Jam protection operative) |
| MANUAL DOWN | Operative (Jam protection not operative) |
| AUTO UP (hold switch at AUTO UP position) | Operative (Jam protection operative) |
| AUTO UP | Operative (Jam protection operative) |
| AUTO DOWN | Operative (Jam protection not operative) |