Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK BATTERY VOLTAGE
If the voltage is below 11 V, recharge the battery before proceeding.

Standard battery voltage:
11 to 14 V


DIAGNOSIS SYSTEM


  1. Warning light



      C213286E04
    1. When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals, and turns on after 1 minute.
      Text in Illustration 
      *1
      Tire Pressure Warning Light

  2. DTCs (Normal mode)

    1. DTCs are stored in the tire pressure warning ECU and output by the blinks of the tire pressure warning light or by using the Techstream (Click here).

  3. Test mode

    1. By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, and the vehicle speed sensor can be inspected (Click here).


CHECK TIRE PRESSURE WARNING LIGHT


    C213286E05
  1. Turn the ignition switch to ON.
    Text in Illustration 
    *1
    Tire Pressure Warning Light

  2. Check that the tire pressure warning light turns on for 3 seconds.
    If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
    Trouble Area
    See procedure
    Tire pressure warning light circuit
    Click here


TIRE PRESSURE WARNING LIGHT CHART

HINT:
The table below indicates the state of the tire pressure warning light after the ignition switch is turned ON.

Condition
Immediately after turning ignition switch ON
Always
Warning light output pattern
Turns on for 3 seconds
Goes off
Turns on
Blinks for 1 minute and then illuminates (*1)
Blinks (*2)
Blinks (*3)
Blinks (*4)
Output DTC
Normal
○
○
-
-
-
-
-
-
Low tire pressure
○
-
○
-
-
-
-
-
System failure
○
-
-
○
-
-
-
-
Signal Check
○
-
-
-
○
-
-
-
Initialization
○
-
-
-
-
○
-
-
ECU connector poorly connected
-
-
-
○ (*5)
-
-
-
-
TC ground (DTC is output)
○
-
-
-
-
-
-
○
TC ground (DTC is not output)
○
-
-
-
-
-
○
-


  1. E133091E02
    *1: Turns on and goes off repeatedly at 0.5 second intervals, and turns on after 1 minute.

  2. C110635E08
    *2: Turns on and goes off repeatedly at 0.125 second intervals.

  3. C110636E02
    *3: Blinks 3 times (1 second on, 1 second off).

  4. C145821E02
    *4: Turns on and goes off repeatedly at 0.25 second intervals.

  5. C147995E02
    *5: When there is an open circuit, the light is off for 10 seconds. Then it blinks at 0.5 second intervals, and turns on after 1 minute.