POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > TERMINALS OF ECU |
| CHECK MULTIPLEX TILT AND TELESCOPIC ECU |

Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| A-2 (TEM+) - J47-11 (GND) | (Not available) - W-B | Telescopic motor output |
| 11 to 14 V |
| Telescopic motor is not operating | Below 1 V | |||
| A-3 (VCE) - A-5 (E2) | (Not available) | Telescopic sensor power source | Ignition switch ON | 8 to 16 V |
| A-4 (TES) - A-5 (E2) | (Not available) | Telescopic sensor signal | Telescopic motor is operating | Pulse generation High: 8 to 16 V Low: Below 1 V |
| A-5 (E2) - Body ground | (Not available) - Body ground | Telescopic sensor ground | Always | Below 1 V |
| A-6 (TEM-) - J47-11 (GND) | (Not available) - W-B | Telescopic motor output |
| 11 to 14 V |
| Telescopic motor is not operating | Below 1 V | |||
| J47-1 (TIM-) - J47-11 (GND) | R - W-B | Tilt motor output |
| 11 to 14 V |
| Tilt motor is not operating | Below 1 V | |||
| J47-2 (+B) - J47-11 (GND) | P - W-B | Motor power source | Always | 11 to 14 V |
| J47-3 (MSW) - J47-11 (GND) | GR - W-B | Manual switch signal |
| 1.67 to 2.13 V |
| 0.54 to 0.74 V | |||
| 1.08 to 1.40 V | |||
| 2.22 to 2.77 V | |||
| Manual switch is not operating | Below 0.2 V | |||
| J47-3 (MSW) - J47-4 (VC) | GR - Y | Tilt and telescopic manual switch signal | Ignition switch ON | 4.9 to 5.1 V |
| J47-4 (VC) - J47-11 (GND) | Y - W-B | Manual switch power source | Ignition switch ON | 4.9 to 5.1 V |
| J47-5 (CANH) - J47-11 (GND) | BE - W-B | CAN communication | Ignition switch ON | Below 1 V |
| J47-6 (VCI) - J47-17 (E1) | SB - BR | Tilt sensor power source | Ignition switch ON | 8 to 16 V |
| J47-7 (TIS) - J47-17 (E1) | G - BR | Tilt sensor signal | Tilt motor is operating | Pulse generation High: 8 to 16 V Low: Below 1 V |
| J47-8 (IG) - J47-11 (GND) | P - W-B | IG signal / IG power source | Ignition switch ON | 11 to 14 V |
| Ignition switch OFF | Below 1 V | |||
| J47-9 (ECUB) - J47-11 (GND) | L - W-B | ECU power source | Always | 11 to 14 V |
| J47-10 (TIM+) - J47-11 (GND) | B - W-B | Tilt motor output |
| 11 to 14 V |
| Tilt motor is not operating | Below 1 V | |||
| J47-11 (GND) - Body ground | W-B - Body ground | ECU ground | Always | Below 1 V |
| J47-14 (CANL) - J47-11 (GND) | W - W-B | CAN communication | Ignition switch ON | Below 1 V |
| J47-17 (E1) - Body ground | BR - Body ground | Tilt sensor ground | Always | Below 1 V |