Home › STEERING › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

DTC    B2620    ECU Power Source Circuit Malfunction

for Preparation Click here


DESCRIPTION

The ECU power source circuit supplies positive voltage to the multiplex tilt and telescopic ECU.

DTC Code
Detection Condition
Trouble Area
B2620
While the auto away/return function, driving position memory function or manual control is in operation, the ECU power supply voltage remains at 10 V or less for 10 sec. or more after a voltage of 8 V or less is detected.
  1. Battery
  2. Harness or connector
  3. Multiplex tilt and telescopic ECU

WIRING DIAGRAM


C159209E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B1)
  1. Remove the ECU-B1 fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)


    C149087E16
  1. Disconnect the J47 multiplex tilt and telescopic ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    J47-9 (ECUB) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)


    C149087E18
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J47-11 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)