FUEL TANK > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE FUEL TANK CAP |
| 5. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel tank main tube sub-assembly (Click here).
| 6. DISCONNECT FUEL TANK RETURN TUBE |
![]() |
Disconnect the fuel tank return tube (Click here).
| 7. DISCONNECT VENT LINE HOSE |
![]() |
Pull up the retainer and disconnect the vent line hose.
| *1 | Retainer |
![]() | Pull Up |
| 8. DISCONNECT WIRE HARNESS |
![]() |
Detach the harness clamp from the fuel tank assembly.
| 9. DISCONNECT FUEL TANK TO FILLER PIPE HOSE |
![]() |
Disconnect the fuel tank breather tube (Click here).
Disconnect the fuel tank to filler pipe hose from the fuel tank inlet pipe sub-assembly.
Detach the fuel tank to filler pipe hose and fuel tank breather tube from the No. 1 breather tube clamp.
| 10. DISCONNECT NO. 1 CANISTER OUTLET HOSE |
Disconnect the No. 1 canister outlet hose from the fuel tank inlet pipe sub-assembly.
Detach the fuel tank to filler pipe hose from the No. 1 breather tube clamp.
| 11. REMOVE FUEL TANK ASSEMBLY |
Set a engine lifter underneath the fuel tank assembly.
![]() |
Remove the 2 bolts, 2 clips, 2 pins, No. 1 fuel tank band sub-assembly and No. 2 fuel tank band sub-assembly.
Slowly lower the engine lifter slightly.
![]() |
w/ Cover:
Detach the 3 claws to remove the No. 2 fuel tank protector.
![]() |
Detach the wire harness clamp from the fuel tank assembly as shown in the illustration.
Disconnect the fuel pump connector and lower the engine lifter.
| 12. REMOVE FUEL TANK INLET PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and fuel tank inlet pipe sub-assembly.
| 13. REMOVE NO. 1 FUEL TANK HEAT INSULATOR |
![]() |
Remove the nut from the No. 1 fuel tank heat insulator.
| *1 | Nut |
Using needle-nose pliers, remove the 4 clips shown in the illustration and then remove the No. 1 fuel tank heat insulator.
| 14. REMOVE FUEL TANK TO FILLER PIPE HOSE |
![]() |
Remove the fuel tank to filler pipe hose from the fuel tank assembly.
| 15. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Remove the 2 tube joint clips and pull out the fuel tank return tube and fuel tank main tube sub-assembly.
| *1 | Tube Joint |
| *2 | Tube Joint Clip |
| *3 | O-Ring |
| *4 | Fuel Tank Tube |
| *5 | Fuel Suction Plate |
![]() |
Set SST on the retainer.
![]() |
Using SST, loosen the retainer.
Remove the retainer.
Remove the fuel suction with pump and gauge tube assembly from the fuel tank assembly.
Remove the gasket from the fuel tank assembly.
| 16. REMOVE NO. 1 FUEL TANK PROTECTOR (w/ Cover) |
![]() |
Detach the 4 clamps to remove the No. 1 fuel tank protector.