DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation |
| DTC Code | DTC Detection Condition | Trouble Area |
| P011B |
|
|

| Related DTCs | P011B: Engine Coolant Temperature (ECT) / Intake Air Temperature (IAT) sensor correlation |
| Required Sensors/Components (Main) | ECT / IAT sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | - |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not stored | None |
| All of following conditions met | Conditions 1 and 2 |
| 1. All of following conditions met | Conditions (a), (b), (c) and (d) |
| (a) After ignition switch ON and engine not running time | Less than 15 seconds |
| (b) Soak Time | 7 hours or more |
| (c) Battery voltage | 10.5 V or higher |
| (d) Time after engine start | 15 seconds or more |
| 2. Either of the following conditions are met | Condition (a) and (b) |
| (a) Minimum IAT after engine start | -10°C (14°F) or higher |
| (b) ECT before engine start | -10°C (14°F) or higher |
| MAF sensor circuit fail (P0102, P0103) | Not detected |
| IAT sensor circuit fail (P0112, P0113) | Not detected |
| ECT sensor circuit fail (P0115, P0117, P0118, P0125) | Not detected |
| Soak timer circuit fail (P2610) | Not detected |
| Deviated temperature (difference between ECT and IAT) | Below -25°C (-45°F) or higher than 25°C (45°F) |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P011B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P011B | A |
| P011B and other DTCs | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (INTAKE AIR TEMPERATURE) |
Leave the vehicle for 7 hours or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / All Data / Intake Air.
Read the value displayed on the Techstream.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / All Data / Coolant Temp.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||