PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Install the switch to the manual valve shaft.
![]() |
Temporarily install the bolt.
![]() |
Install a new lock washer and the nut.
![]() |
Temporarily install the control shaft lever RH.
![]() |
Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
![]() |
Align the groove with the neutral basic line.
Hold the switch in position and tighten the bolt.
![]() |
Using a screwdriver, bend the tabs of the lock washer.
![]() |
Install the transmission control shaft lever RH with the spring washer and nut.
Connect the switch connector.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Connect the cable with the nut.
| 3. ADJUST SHIFT LEVER POSITION (for Column Shift Type) |
Move the shift lever to N.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press out the lock piece from the back side to release the lock.
![]() |
Check that the spring of the adjust case is applying enough tension to the shift control cable. Then press in the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the shift lever operation after the adjustment.
| 4. ADJUST SHIFT LEVER POSITION (for Floor Shift Type) |
Move the shift lever to N.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press out the lock piece from the back side to release the lock.
| *1 | Lock Piece |
| *2 | Slider |
![]() |
Check that the spring of the adjust case is applying enough tension to the shift control cable. Then press in the lock piece to set the lock.
| *1 | Lock Piece |
| *2 | Slider |
Return the cover of the adjust case to its original position.
Inspect the shift lever operation after the adjustment.
| 5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Inspect the switch (Click here).