Home › TRANSMISSION ยท AB60E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Install the switch to the manual valve shaft.



    C161110
  1. Temporarily install the bolt.



    C161109E01
  1. Install a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }



    C161107
  1. Temporarily install the control shaft lever RH.



    C155873E01
  1. Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

  1. Remove the control shaft lever RH.



    D025795E10
  1. Align the groove with the neutral basic line.

  1. Hold the switch in the position described above and tighten the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    C161108
  1. Using a screwdriver, bend the tabs of the lock washer.



    C161107
  1. Install the transmission control shaft lever RH with the spring washer and nut.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

  1. Connect the switch connector.



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


C161106
  1. Connect the cable with the nut.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

    NOTICE:
    When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the outside of the vehicle.



3. ADJUST SHIFT LEVER POSITION
  1. Adjust the shift lever position (Click here).



4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Inspect the switch (Click here).