Home › TRANSMISSION ยท A760E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF, and install it to the transmission wire connector.



    C125286
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    C155913
  1. Connect the transmission wire connector.

    HINT:
    Push up the lever until the claw of the transmission wire connector makes a connection sound.



2. CONNECT TRANSMISSION WIRE


C209349E01
  1. Connect the 9 solenoid valve connectors.

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.41 in.) for bolt B

  1. Attach the wire harness to the 2 clamps.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


C209698
  1. Coat a new O-ring with ATF, and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C209348

NOTICE:
Be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).