Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > TERMINALS OF ECU

for Preparation Click here



CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

C290645E04

  1. Disconnect the J137 and J139 radio and display receiver assembly connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specification
    J137-3 (ACC1) - J137-7 (GND1)
    GR - W-B
    Power source (ACC)
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V
    J137-4 (+B1) - J137-7 (GND1)
    V - W-B
    Power source (+B)
    Always
    11 to 14 V
    J137-7 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    J139-1 (IG) - J137-7 (GND1)
    P - W-B
    Power source (IG)
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

  3. Reconnect the J137 and J139 radio and display receiver assembly connectors.

  4. Measure the voltage and waveform according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specification
    J139-2 (REV) - J137-7 (GND1)
    Y - W-B
    Reverse signal
    Ignition switch ON, shift lever in R
    7.5 to 14 V
    Ignition switch ON, shift lever not in R
    Below 1 V
    J140-11 (CA+) - J140-23 (CGND)
    B - Shielded
    Power source
    Ignition switch ACC
    5.5 to 7.05 V
    J140-12 (V+) - J140-24 (V-)
    R - W
    Display signal
    Ignition switch ON
    Pulse generation (See waveform 1)
    Ignition switch ON, screen blacked out by covering camera lens
    Pulse generation (See waveform 2)
    J140-23 (CGND) - Body ground
    Shielded - Body ground
    Shielded ground
    Always
    Below 1 V



  5. E171712E24
  6. Using an oscilloscope, check the waveform.

    1. Waveform 1
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      J140-12 (V+) - J140-24 (V-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

    2. Waveform 2
      Measurement Condition 
      Item
      Content
      Terminal No. (Symbol)
      J140-12 (V+) - J140-24 (V-)
      Tool Setting
      0.2 V/DIV., 50 μs/DIV.
      Condition
      Ignition switch ON, screen blacked out by covering camera lens

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

      Text in Illustration 
      *a
      Waveform 1
      *b
      Waveform 2
      *c
      Synchronized Signal
      *d
      Video Waveform