Home › ENGINE ยท 1UR-FE › COOLING › FAN

FAN > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    A215892E01

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE AIR CLEANER ASSEMBLY


    A272399E01
  1. Detach the clamp and disconnect the mass air flow meter connector.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner assembly.



5. REMOVE INLET RADIATOR HOSE


    A215577
  1. Remove the radiator hose.



6. REMOVE FAN SHROUD


    A217580
  1. Loosen the 4 nuts holding the fluid coupling fan

  1. Remove the fan and generator V-belt (Click here).

  1. Disconnect the reservoir hose from the upper radiator tank.



    A151821
  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the fan bracket.



7. REMOVE FAN


    A151830
  1. Remove the 4 nuts and fan from the fluid coupling.