Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT WIPER AND WASHER SWITCH ASSEMBLY


E146708E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Windshield wiper switch 
    Tester Connection
    Switch Condition
    Specified Condition
    B-3 (+1) - B-2 (+B)
    MIST
    Below 1 Ω
    B-3 (+1) - B-1 (+S)
    OFF
    B-3 (+1) - B-1 (+S)
    INT
    B-3 (+1) - B-2 (+B)
    LO
    B-4 (+2) - B-2 (+B)
    HI
    Windshield washer switch 
    Tester Connection
    Switch Condition
    Specified Condition
    A-3 (WF) - A-2 (EW)
    OFF
    10 kΩ or higher
    ON
    Below 1 Ω

    If the result is not as specified, replace the switch assembly.



    E146708E04
  1. Check the intermittent operation.

    1. Connect the voltmeter's positive (+) lead to terminal B-3 (+1) and the negative (-) lead to terminal A-2 (EW).

    2. Connect the battery's positive (+) lead to terminal B-2 (+B) and the negative (-) lead to terminals A-2 (EW) and B-1 (+S).

    3. Turn the wiper switch to the INT position.

    4. Connect the battery's positive (+) lead to terminal B-1 (+S) for 5 seconds.



    5. Connect the battery's negative (-) lead to terminal B-1 (+S). Operate the intermittent wiper relay and check the voltage between terminals B-3 (+1) and A-2 (EW).

      OK:
      Refer to illustration below.



      E146261E03

      If the result is not as specified, replace the switch assembly.



    E146708E05
  1. Check the washer operation.

    1. Turn the wiper switch OFF.

    2. Connect the battery's positive (+) lead to terminal B-2 (+B) and the negative (-) lead to terminals B-1 (+S) and A-2 (EW).

    3. Connect the voltmeter's positive (+) lead to terminal B-3 (+1) and the negative (-) lead to terminal A-2 (EW).



    4. Turn the washer switch ON and OFF, and check the voltage between terminals B-3 (+1) and A-2 (EW).

      OK:
      Refer to illustration below.



      B086335E07

      If the result is not as specified, replace the switch assembly.