Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 1GR-FE)

COMPRESSOR (for 1GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT COOLER COMPRESSOR ASSEMBLY


    E127549E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SSR+) - 2 (SSR-)
    20°C (68°F)
    165 to 205 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Compressor Assembly)
    If the resistance is not as specified, replace the cooler compressor assembly.



2. INSPECT MAGNET CLUTCH ASSEMBLY


    E168814E02
  1. Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
    Text in Illustration 
    *1
    Battery
    *2
    Magnet Clutch Rotor
    *3
    Magnet Clutch Hub
    *a
    Component without harness connected
    (Cooler Compressor Assembly)
    If the operation is not as specified, replace the magnet clutch assembly.