Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for UR Engine Series)

COMPRESSOR (for UR Engine Series) > INSPECTION

for Preparation Click here



1. INSPECT COOLER COMPRESSOR ASSEMBLY


    E127549E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SSR+) - 2 (SSR-)
    20°C (68°F)
    65 to 125 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Magnet Clutch Assembly)
    If the resistance is not as specified, replace the cooler compressor assembly.



2. INSPECT MAGNET CLUTCH ASSEMBLY


    E168830E02
  1. Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
    Text in Illustration 
    *1
    Battery
    *2
    Magnet Clutch Rotor
    *3
    Magnet Clutch Hub
    *a
    Component without harness connected
    (Magnet Clutch Assembly)
    If the operation is not as specified, replace the magnet clutch assembly.