STEERING KNUCKLE > INSTALLATION |
| 1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD) |
![]() |
Using a brass bar and hammer, tap in a new retainer cap.
| 2. INSTALL STEERING KNUCKLE OIL SEAL LH |
![]() |
Using SST and a press, press in a new oil seal.
| 3. INSTALL STEERING KNUCKLE LH |
Install the front suspension upper arm to the steering knuckle with the nut.
Install a new clip.
| 4. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH |
![]() |
Connect the attachment to the steering knuckle with the 2 bolts.
| 5. CONNECT TIE ROD END SUB-ASSEMBLY LH |
Connect the tie rod end LH to the steering knuckle with the nut.
Install a new cotter pin.
| 6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH |
Install the front axle hub (Click here).
| 7. CONNECT FRONT SPEED SENSOR LH |
![]() |
Connect the front speed sensor to the steering knuckle with the bolt.
Attach the clip to the steering knuckle.
| 8. INSTALL FRONT WHEEL |
| 9. CHECK SPEED SENSOR SIGNAL |
Check the speed sensor signal .
| 10. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).