ENGINE OIL COOLER > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

| *1 | Radiator Reservoir | *2 | Radiator Cap |
| *3 | Radiator Drain Cook Plug | *4 | Cylinder Block Drain Cock Plug |
Remove the radiator cap. Then drain the coolant.
Tighten the 2 cylinder block drain cock plugs.
Tighten the radiator drain cock plug by hand.
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
| 3. REMOVE OIL FILTER ELEMENT |
![]() |
Connect a hose with an inside diameter of 15 mm (0.591 in.) to the pipe.
| *1 | Pipe |
| *2 | Hose |
![]() |
Remove the oil filter drain plug.
![]() |
Install the pipe to the oil filter cap.
| *1 | Cap |
| *2 | Valve |
| *3 | Pipe |
| *4 | O-Ring |
| *5 | Hose |
![]() |
Check that oil is drained from the oil filter. Then, disconnect the pipe as shown in the illustration and remove the O-ring.
![]() |
Using SST, remove the oil filter cap.
| *1 | Oil Filter Bracket Clip |
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| *1 | O-Ring |
| 4. DISCONNECT WATER BY-PASS PIPE SUB-ASSEMBLY |
![]() |
Remove the 3 bolts.
![]() |
Disconnect the 2 hoses and water by-pass pipe.
| 5. REMOVE OIL FILTER BRACKET |
![]() |
Remove the 2 nuts, bolt, oil filter bracket and gasket.
| 6. REMOVE OIL COOLER ASSEMBLY |
![]() ![]() |
Remove the 2 hoses.
Remove the bolt, nut and oil cooler.
Remove the seal washer from the bolt.