CAMSHAFT OIL CONTROL VALVE > ON-VEHICLE INSPECTION |
| 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Inspect the oil control valve (for intake camshaft).
Enter the following menus: Powertrain / Engine / Active Test / Control the VVT System (Bank 1).
Operate the oil control valve using the Techstream, and then check the engine speed.
| Control Range | Specified Condition |
| OFF | Normal engine speed |
| ON | Rough idle or engine stalls soon after oil control valve switched from OFF to ON |
Enter the following menus: Powertrain / Engine / Active Test / Control the VVT System (Bank 2).
Operate the oil control valve using the Techstream, and then check the engine speed.
| Control Range | Specified Condition |
| OFF | Normal engine speed |
| ON | Rough idle or engine stalls soon after oil control valve switched from OFF to ON |
Inspect the oil control valve (for exhaust camshaft).
Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 1).
Operate the oil control valve using the Techstream, and then check the engine speed.
| Control Range | Specified Condition |
| -100% | Normal engine speed |
| 100% | Rough idle or engine stalls soon after oil control valve switched to 100% |
Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 2).
Operate the oil control valve using the Techstream, and then check the engine speed.
| Control Range | Specified Condition |
| -100% | Normal engine speed |
| 100% | Rough idle or engine stalls soon after oil control valve switched to 100% |