Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for UR Engine Series)

COMPRESSOR (for UR Engine Series) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. REMOVE FRONT FENDER APRON SEAL LH


    E143269
  1. Remove the 6 clips and front fender apron seal LH.



3. REMOVE FAN AND GENERATOR V BELT
for 1UR-FE: (Click here)
for 3UR-FE: (Click here)
for 3UR-FBE: (Click here)


4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E147757
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler compressor assembly.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


    E147758
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the cooler compressor assembly.

  1. Remove the O-ring from the No. 1 cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. REMOVE COOLER COMPRESSOR ASSEMBLY


    E147759
  1. Disconnect the connector.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the 2 stud bolts and cooler compressor assembly.