REAR SPEED SENSOR > INSTALLATION |
| 1. INSTALL SKID CONTROL SENSOR WIRE |
Install the sensor clamp with the nut (labeled A).
Install the sensor clamp with the bolt (labeled B).
Attach the 7 clips (labeled C).
Connect the sensor connector (labeled D).

| 2. INSTALL REAR SPEED SENSOR LH |
![]() |
Install the speed sensor (labeled A) with the nut (labeled B).
Connect the speed sensor connector (labeled C).
| 3. INSTALL REAR SPEED SENSOR RH |
![]() |
Install the speed sensor (labeled A) with the nut (labeled B).
Connect the speed sensor connector (labeled C).
| 4. INSTALL REAR WHEEL |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK SPEED SENSOR SIGNAL |
Check the speed sensor signal (Click here).