BACK POWER WINDOW SWITCH > INSPECTION |
| 1. INSPECT BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition | |
| 6 (UP) - 2 (E) | Pull (Close) | Pulled | Below 1 Ω |
| Not pulled | 10 kΩ or higher | ||
| 4 (DOWN) - 2 (E) | Push (Open) | Pushed | Below 1 Ω |
| Not pushed | 10 kΩ or higher | ||
| *a | Component without harness connected (Back Door Power Window Regulator Switch Assembly) |
| *b | Pull (Close) |
| *c | Push (Open) |
Check that the LED illuminates.
Apply battery voltage to the back door power window regulator switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 8 (ILL+) Battery negative (-) → 1 (ILL-) | LED illuminates |
| 2. INSPECT BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Power Slide Type) |
![]() |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition | |
| 6 (UP) - 2 (E) | Pull (Close) | Pulled | Below 1 Ω |
| Not pulled | 10 kΩ or higher | ||
| 4 (DOWN) - 2 (E) | Push (Open) | Pushed | Below 1 Ω |
| Not pushed | 10 kΩ or higher | ||
Check that the LED illuminates.
Apply battery voltage to the back door power window regulator switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 8 (ILL+) Battery negative (-) → 1 (ILL-) | LED illuminates |
| *a | Component without harness connected (Back Door Power Window Regulator Switch Assembly) |
| *b | Pull (Close) |
| *c | Push (Open) |