Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL SAFE OPERATION
  1. If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the VSC actuator and informs the ECM of VSC system failure.
    The VSC actuator turns off each solenoid and the ECM shuts off VSC control (traction control signal) from the skid control ECU. As a result, it is as if the ABS, TRAC and VSC systems are not installed in the vehicle.
    The ABS control will be prohibited, but EBD control continues as much as possible. If EBD control is impossible, the BRAKE warning light comes on to warn the driver (Click here).
  2. If system components have any malfunction before starting control, immediately stop the operation.
    If system components have any malfunction during control, gradually stop the control so as not to trigger a sudden change in vehicle conditions.
    If it is impossible to control the systems, the warning/indicator lights come on or blink to inform the driver of termination of the systems (Click here).
  3. w/o Multi-information Display:
    VSC control continues as much as possible while the TRAC OFF indicator light is on even if the engine failed.
    w/ Multi-information Display:
    VSC control continues as much as possible while TRAC OFF is displayed on the multi-information display even if the engine failed.

HINT:
  1. If the ABS, BA, TRAC, A-TRAC, VSC and AUTO LSD systems encounter a malfunction, the brake system will operate normally without ABS, BA, TRAC, A-TRAC, VSC and AUTO LSD control.
  2. If there is a problem with the VSC actuator, brake performance will gradually decrease and control of the ABS, BA, TRAC, A-TRAC, VSC and AUTO LSD systems will be prohibited.

  1. ABS, EBD and BA system:

    Malfunction Area
    Control Method
    ABS system
    ABS, BA, TRAC, A-TRAC, VSC and AUTO LSD control is prohibited
    BA system
    ABS, BA, TRAC, A-TRAC, VSC and AUTO LSD control is prohibited
    EBD system
    ABS, EBD, BA, TRAC, A-TRAC, VSC and AUTO LSD control is prohibited

  2. TRAC, A-TRAC, VSC and AUTO LSD system:

    HINT:
    As for the TRAC, A-TRAC, VSC and AUTO LSD systems, different systems prohibit different controls according to a malfunctioning part.


    Malfunction Area
    Control Method
    Engine control system
    Before control: Disables control
    During control: Disables control (Enables VSC)
    Brake control system
    (VSC system)
    Before control: Disables control
    During control: Disables control
    Brake control system
    (TRAC, A-TRAC and AUTO LSD systems)
    Before control: Disables control
    During control: Disables control (by gradually ending control)


SYSTEM TEMPERATURE PROTECTION OPERATION
If the TRAC, A-TRAC or AUTO LSD system has been used constantly for a long time, the temperature of the brake pads may excessively increase. If the temperature increases even more, the indicator lights come on or blink.

System
Indicator Condition
TRAC or A-TRAC system
SLIP indicator light comes on
AUTO LSD system
SLIP indicator light comes on
AUTO LSD indicator light goes off
Abnormal brake pad temperature
TRAC OFF indicator light comes on

HINT:
If the systems automatically return to normal operating conditions, the SLIP indicator light goes off. As this is not a malfunction, no DTC will be recorded.