TIRE PRESSURE WARNING VALVE AND TRANSMITTER > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
Install a new grommet to the tire pressure warning valve and transmitter.
![]() |
Insert the tire pressure warning valve and transmitter into the valve installation hole from the inside of the rim so that the printed surface can be seen.
| *a | Printed Surface |
| *b | 8-digit Number Transmitter ID |
![]() |
From the outside of the rim, install the washer to the tire pressure warning valve and transmitter, and install the nut.
| *1 | Tire Pressure Warning Valve and Transmitter |
| *2 | Rim |
| *3 | Grommet |
| *4 | Washer |
| *5 | Nut |
![]() |
Set the wheel onto a mounting machine and install the lower bead. Position the main body of the tire pressure warning valve and transmitter in the shaded area shown in the illustration.
| *1 | Rim |
| *a | Mount Tool of Mounting Machine |
| *b | Area for Tire Pressure Warning Valve and Transmitter |
| *c | 60° |
![]() | Rim Rotation Direction |
Install the upper bead.
Install a new valve core.
After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque.
Check for air leaks with soapy water.
If there is air leakage, push the valve core 2 or 3 times to remove any dirt attached to the valve core. If air continues to leak, replace the grommet, washer and nut.
Install the cap.
| 2. INSTALL FRONT WHEEL |
| 3. INSTALL REAR WHEEL |
| 4. INSPECT TIRES |
| 5. REGISTER TRANSMITTER ID |
| 6. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 7. PERFORM INITIALIZATION |