BRAKE ACTUATOR > INSTALLATION |
| 1. INSTALL VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY |
![]() |
Install the VSC actuator with actuator bracket with the 3 nuts.
Tighten the 3 nuts uniformly in alphabetical order.
| 2. CONNECT BRAKE TUBE |
![]() |
Set each brake line to the correct position on the brake actuator as shown in the illustration.
Install a new clamp onto the VSC actuator bracket.
![]() |
Using a union nut wrench, connect the 4 brake tubes.
| 3. INSTALL BRAKE TUBE |
![]() |
Using a union nut wrench, connect the 2 brake tubes to the brake master cylinder.
![]() |
Using a union nut wrench, connect the 2 brake tubes to the VSC actuator.
| 4. CONNECT VSC ACTUATOR CONNECTOR |
![]() |
Connect the VSC actuator connector.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. BLEED BRAKE SYSTEM |
Bleed brake master cylinder
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
Block the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
Bleed brake line
Connect a vinyl tube to the bleeder plug of the front disc brake cylinder RH.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2
Repeat *1 and *2 until all the air in the brake fluid is completely bled out and the new brake fluid comes out.
Tighten the bleeder plug completely.
Replace the brake fluid from the front disc brake cylinder LH using the same procedure as for RH.
Connect a vinyl tube to the bleeder plug of the rear disc brake cylinder RH.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2
Repeat *1 and *2 until all the air in the brake fluid is completely bled out and the new brake fluid comes out.
Tighten the bleeder plug completely.
Replace the brake fluid from the rear disc brake cylinder LH using the same procedure as for RH.
Bleed VSC actuator assembly
Depress the brake pedal more than 20 times with the engine off.
Connect the Techstream to the DLC3, and turn the ignition switch on.
Select AIR BLEEDING on the Techstream.
Bleed the air out of the suction line.
Bleed the air out of the pressure reduction line.
Clear the DTCs (Click here).
Inspect for brake fluid leak.
Check and adjust brake fluid level in reservoir .
If any DTC is set, perform the troubleshooting for the DTC
Check the DTC (Click here).