Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR

BRAKE ACTUATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. DISCONNECT VSC ACTUATOR CONNECTOR


    C154434
  1. Pull the release bar and disconnect the VSC actuator connector.



4. REMOVE BRAKE TUBE


    C154437E03
  1. Use tags or make a note to identify the reconnection locations.

    HINT:
    1. *1: FR RH
    2. *2: FR LH
    3. *3: RR RH
    4. *4: RR LH
    5. *5: FR Master Cylinder
    6. *6: RR Master Cylinder



    C208906
  1. Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.



    C208907
  1. Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.



5. DISCONNECT BRAKE TUBE


    C208908
  1. Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.

  1. Remove the clamp from the VSC actuator bracket.



6. REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY


    C155484
  1. Remove the 3 nuts and VSC actuator with actuator bracket.