Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR (for Steel Type Bumper)


    B354821
  1. Install the No. 1 ultrasonic sensor as shown in the illustration.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor.



2. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Steel Type Bumper)


    B354820
  1. Install the No. 1 ultrasonic sensor retainer as shown in the illustration.



3. INSTALL NO. 1 ULTRASONIC SENSOR (for Resin Type Bumper)



B354822E01

  1. Attach the 4 claws to install the No. 1 ultrasonic sensor as shown in the illustration.
    Text in Illustration 
    *a
    No. 1 ultrasonic sensor direction
    *b
    Keyhole direction

    NOTICE:
    1. No. 1 ultrasonic sensor direction is the same as the keyhole direction.
    1. Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor.



4. INSTALL FRONT BUMPER COVER
  1. w/ Fog Light:

    1. Connect the fog light connectors.

  1. w/ Intuitive Parking Assist System:

    1. Connect the ultrasonic sensor connectors.

    2. Attach the 4 clamps to connect the wire harness.

  1. Install the front bumper cover with the 4 bolts.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }



    B354984E01
  1. Install the 4 screws labeled A and 3 screws labeled B.

    Torque:
    for screw B:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

    Text in Illustration 
    *1
    Screw A
    *2
    Screw B
    *3
    Bolt

  1. Install the 4 bolts.

    Torque:
    for bolt:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

  1. for Steel Type Bumper:

    1. Install the 2 pin hold clips.

      HINT:
      Use the same procedure for the RH and LH sides.

  1. for Resin Type Bumper:

    1. Install the 2 screws.

      HINT:
      Use the same procedure for the RH and LH sides.



5. INSTALL FRONT BUMPER CENTER UPPER RETAINER
  1. Install the front bumper center upper retainer with the 6 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL FRONT END PANEL LH
  1. Attach the 3 claws to install the front end panel LH.

  1. Install the 2 screws and 2 clips.



7. INSTALL FRONT END PANEL RH

HINT:
Use the same procedure described for the LH side.



8. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


9. ADJUST FOG LIGHT
  1. Adjust the fog light (Click here).