REAR CROSS TRAFFIC ALERT BUZZER (for Regular Cab) > REMOVAL |
| 1. REMOVE UPPER BACK PANEL GARNISH |
![]() |
Detach the 10 clips and remove the upper back panel garnish.
| 2. REMOVE LUGGAGE COMPARTMENT BOX LH |
![]() |
Remove the 2 clips.
Detach the 3 claws and remove the luggage compartment box LH.
| 3. REMOVE LUGGAGE COMPARTMENT BOX RH |
![]() |
Remove the 4 clips and luggage compartment box RH.
| 4. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.
| 5. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the nut.
Detach the 2 clips and remove the cowl side trim board LH.
| 6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
Remove the front door opening trim weatherstrip LH.
| 7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH |
![]() |
Detach the 2 claws and remove the cover.
![]() |
Loosen the bolt and disconnect the front seat outer belt assembly LH.
![]() |
Detach the 7 clips and remove the lower quarter trim panel assembly LH.
| 8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
![]() |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a screwdriver, detach the claw and open the cover.
Detach the 2 claws and open the shoulder belt anchor cover.
Loosen the bolt and disconnect the front seat outer belt assembly LH.

![]() |
Remove the 2 bolts.
Detach the 5 clips and remove the front quarter trim panel assembly LH.
| 9. REMOVE BLIND SPOT MONITOR BUZZER |
![]() |
Disconnect the connector.
Detach the clamp and remove the blind spot monitor buzzer.