Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR CROSS TRAFFIC ALERT BUZZER (for Double Cab)

REAR CROSS TRAFFIC ALERT BUZZER (for Double Cab) > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH


    B165598
  1. Pull the 2 reclining adjusting handles and fold up the seat cushion.



    B356738
  1. Turn the knob and open the luggage compartment side cover sub-assembly LH.

  1. Detach the hooks and remove the luggage compartment side cover sub-assembly LH.



2. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH


    B356739
  1. Turn the knob and open the luggage compartment side cover sub-assembly RH.

  1. Detach the hooks and remove the luggage compartment side cover sub-assembly RH.



3. REMOVE SEAT FLOOR BOX


B165790
  1. Remove the 4 knobs.

  1. Detach the claw and remove the seat floor box.



4. REMOVE REAR SEAT ASSEMBLY


    B165600
  1. Remove the 6 bolts.



    B165601
  1. Lift the rear seat assembly to detach the 4 hooks, and remove the rear seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



5. REMOVE REAR DOOR SCUFF PLATE LH


B165842
  1. Detach the 6 claws and 2 clips, and remove the rear door scuff plate LH.



6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Remove the rear door opening trim weatherstrip LH.



7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH


    B165830
  1. Detach the 2 claws and remove the cover.



    B165831
  1. Loosen the bolt and disconnect the rear seat outer belt assembly.



    B165832
  1. Detach the 6 clips and remove the lower quarter trim panel assembly LH.



8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


    B356805E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the claw and open the cover.

    HINT:
    Tape the screwdriver tip before use.



    B356807
  1. Remove the 2 bolts.

  1. Detach the 4 clips and remove the front quarter trim panel assembly LH.

  1. Pass the rear seat outer belt assembly through the hole of the front quarter trim panel assembly LH.



9. REMOVE BLIND SPOT MONITOR BUZZER


    B360665
  1. Disconnect the connector.

  1. Detach the clamp and remove the blind spot monitor buzzer.