Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when a communication error occurs between the transponder key amplifier and transponder key ECU. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.

DTC Code
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurred in communication line
  1. Key
  2. Harness or connector
  3. Transponder key amplifier
  4. Transponder key ECU

WIRING DIAGRAM


B168145E01


INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID .

1.CHECK KEY
E146363
  1. Check whether the ignition key being used is near other ignition keys as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result 
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip
    A
    Key is not near other keys and/or key ring is not in contact with key grip
    B



B
Go to step 3
A


2.CHECK FOR DTC
  1. Separate the keys from each other, or remove the key ring.

  1. Clear the DTC (Click here).

  1. Insert a key into the ignition key cylinder. Remove it. Repeat for all other keys.

  1. Check that no DTC is output (Click here).

    OK:
    DTC B2797 is not output.



NG
Go to step 3
OK

END 

3.CHECK TRANSPONDER KEY ECU (NOISE)
B167622E01
  1. Using an oscilloscope, check for noise in the waveform between the terminals of the J20 amplifier connector and J26 ECU connector.

    OK:
    Tester Connection
    Tool Setting
    Condition
    Specified Condition
    J26-15 (CODE) - J20-4 (CODE)
    5 V/DIV., 20 msec./DIV.
    Key inserted in ignition key cylinder
    No noise is present



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
B110403E30
  1. Disconnect the J26 ECU connector.

  1. Disconnect the J20 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J26-15 (CODE) - J20-4 (CODE)
    Always
    Below 1 Ω
    J26-15 (CODE) or J20-4 (CODE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).


NEXT


6.CHECK WHETHER ENGINE STARTS
  1. Check that the engine starts normally.

    OK:
    Engine starts.



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)