Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM


E146075E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT FUSE (IMB, IGN)
  1. Remove the IMB fuse and IGN fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IMB fuse
    Always
    Below 1 Ω
    IGN fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)


    B110782E14
  1. Disconnect the J26 ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J26-16 (GND) - Body ground
    Always
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J26-1 (+B) - Body ground
    Always
    11 to 14 V
    J26-2 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)