Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > No Answer-Back

for Preparation Click here


DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning lights and/or wireless door lock buzzer answer-back function(s) do not operate. In such cases, the main body ECU's hazard warning lights and wireless door lock buzzer signal outputs may be malfunctioning.

NOTICE:
Troubleshooting should be started after confirming that the customize status of the answer-back function has been switched ON.


WIRING DIAGRAM


B130013E07


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock control functions by operating the transmitter switch.

    Result 
    Result
    Proceed to
    Wireless door lock functions are normal but hazard warning light answer-back does not occur
    A
    Wireless door lock functions are normal but wireless door lock buzzer answer-back does not occur
    B
    Doors cannot be locked and unlocked with transmitter
    C



B
Go to step 3

C
Go to Only Wireless Control Function is Inoperative (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (TURN SIGNAL FLASHER RELAY)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the hazard warning lights flash.

    Main body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Flasher relay
    ON/OFF
    -

OK:
Hazard warning lights turn ON or OFF.



NG
Go to LIGHTING SYSTEM (Click here)
OK

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) 

3.PERFORM ACTIVE TEST USING TECHSTREAM (WIRELESS DOOR LOCK BUZZER)
  1. Select the Active Test, use the Techstream to generate a control command, and then check that the wireless buzzer operates normally.

    Main body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Wireless Buzzer
    Sounds wireless buzzer
    ON/OFF
    -

OK:
Wireless buzzer turns ON or OFF.



NG
Go to step 4
OK

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) 

4.CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU AND BODY GROUND)
E146592E07
  1. Disconnect the A34 buzzer connector.

  1. Disconnect the J1 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A34-1 (B) - J1-7 (BZR)
    Always
    Below 1 Ω
    A34-2 (E) - Body ground
    A34-1 (B) or J1-7 (BZR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK WIRELESS DOOR LOCK BUZZER (OPERATION)
  1. Temporarily replace the wireless door lock buzzer with a new or normally functioning one (Click here).

  1. Check that the buzzer sounds when using the transmitter LOCK and UNLOCK switches.

    OK:
    The buzzer sounds.

    NOTICE:
    When battery voltage is directly applied to the buzzer, the buzzer does not sound.

    HINT:
    The buzzer circuit is built into the main body ECU, not into the buzzer itself.



NG
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
OK

END (WIRELESS DOOR LOCK BUZZER IS DEFECTIVE)