WIRELESS DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) |

Disconnect the DD and DB ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| DD-62 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| DB-13 (BECU) - DD-62 (GND1) | GR - W-B | BECU power supply | Always | 11 to 14 V |
Reconnect the DD and DB ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| J1-5 (KSW) - DD-62 (GND1) | LG - W-B | Key unlock warning switch signal | Key inserted in the ignition key cylinder | Below 1 Ω |
| No key in the ignition key cylinder | 10 kΩ or higher | |||
| J4-24 (DCTY) - Body ground | BR - Body ground | Front door courtesy light switch LH signal | Front door LH open | Below 1 V |
| Front door LH closed | Pulse generation | |||
| J3-21 (PCTY) - Body ground | BE - Body ground | Front door courtesy light switch RH signal | Front door RH open | Below 1 V |
| Front door RH closed | Pulse generation | |||
| DC-2 (LCTY) - Body ground*1, *2 | B - Body ground | Rear door courtesy light switch LH signal | Rear door LH open | Below 1 V |
| Rear door LH closed | Pulse generation | |||
| J3-25 (RRCY) - Body ground*1, *2 | L - Body ground | Rear door courtesy light switch RH signal | Rear door RH open | Below 1 V |
| Rear door RH closed | Pulse generation | |||
| DD-53 (L2) - Body ground | V - Body ground | Front door lock key switch LH input | Front door key cylinder LH to LOCK | Pulse generation |
| Ignition switch OFF, all doors closed and front door key cylinder LH to neutral position | Below 1 V | |||
| J4-10 (UL3) - Body ground | B - Body ground | Front door lock key switch LH input | Front door key cylinder LH to UNLOCK | Pulse generation |
| Ignition switch OFF, all doors closed and front door key cylinder LH to neutral position | Below 1 V | |||
| J4-5 (ACTD) - Body ground | P - Body ground | Front door lock motor LH unlock activation output | Master switch (door control switch) or front door key cylinder LH to LOCK | Below 1 V |
| Master switch (door control switch) or front door key cylinder LH to UNLOCK | Pulse generation | |||
| DD-3 (ACT+) - Body ground | W - Body ground | Door lock motor lock activation output | Master switch (door control switch) or front door key cylinder LH to UNLOCK | Below 1 V |
| Master switch (door control switch) or front door key cylinder LH to LOCK | Pulse generation | |||
| J4-9 (LSWD) - Body ground | P - Body ground | Front door unlock detection switch LH input | Front door LH UNLOCK | Below 1 V |
| Front door LH LOCK | Pulse generation | |||
| DD-2 (ACT-) - Body ground | L - Body ground | Door lock motor unlock activation output | Master switch (door control switch) or front door key cylinder LH to LOCK | Below 1 V |
| Master switch (door control switch) or front door key cylinder LH to UNLOCK | Pulse generation | |||
| DC-24 (ACT+) - Body ground*1, *2 | W - Body ground | Rear door lock motor LH lock activation output | Master switch (door control switch) or front door key cylinder LH to UNLOCK | Below 1 V |
| Master switch (door control switch) or front door key cylinder LH to LOCK | Pulse generation | |||
| DC-23 (ACT-) - Body ground*1, *2 | L - Body ground | Rear door lock motor LH unlock activation output | Master switch (door control switch) or front door key cylinder LH to UNLOCK | Below 1 V |
| Master switch (door control switch) or front door key cylinder LH to LOCK | Pulse generation | |||
| J3-27 (LSWP) - Body ground | V - Body ground | Front door unlock detection switch RH input | Front door RH UNLOCK | Below 1 V |
| Front door RH LOCK | Pulse generation | |||
| DC-1 (LSWL) - Body ground*1, *2 | GR - Body ground | Rear door unlock detection switch LH input | Rear door LH UNLOCK | Below 1 V |
| Rear door LH LOCK | Pulse generation | |||
| J3-5 (LSWR) - Body ground*1, *2 | Y - Body ground | Rear door unlock detection switch RH input | Rear door RH UNLOCK | Below 1 V |
| Rear door RH LOCK | Pulse generation | |||
| J3-10 (PRG) - Body ground | SB - Body ground | Door control receiver output | Key inserted in ignition key cylinder → As key pulled out of ignition key cylinder | 11 to 14 V → Pulse generation → 11 to 14 V |
| J3-12 (RDA) - Body ground | V - Body ground | Door control receiver input | Ignition switch OFF, all doors closed and transmitter switch not pressed | 11 to 14 V |
| Ignition switch OFF, all doors closed and transmitter switch pressed | Pulse generation | |||
| J2-4 (HAZ) - Body ground | BE - Body ground | Hazard warning light signal | Answer-back ON | Pulse generation |
| Answer-back OFF | Below 1 V | |||
| J1-7 (BZR) - Body ground | R - Body ground | Wireless door lock buzzer signal | Answer-back ON | Pulse generation |
| Answer-back OFF | Below 1 V | |||
| J1-6 (SH) - Body ground | W - Body ground | Security horn signal | Panic switch OFF | Below 1 V |
| Panic switch ON | Pulse generation | |||
| DB-1 (HORN) - Body ground | V - Body ground | Vehicle's horn signal | Panic switch OFF | Below 1 V |
| Panic switch ON | Pulse generation |