Home › BRAKE › BRAKE CONTROL › VSC OFF SWITCH

VSC OFF SWITCH > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT SIDE PANEL LH


    B355333
  1. Using a moulding remover B, detach the 3 claws, 4 guides and remove the instrument side panel LH.



2. REMOVE FRONT DOOR SCUFF PLATE LH
  1. for Double Cab:

  1. for CrewMax:

  1. for Regular Cab:



3. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the nut.

  1. Detach the 2 clips and remove the cowl side trim board LH.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Operate the tilt lever to fully extend and raise the steering column.



    B355337E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 bolts <A>.

  1. Detach the 9 clips, 2 claws and remove the lower instrument panel finish panel sub-assembly LH.

  1. Disconnect each connector.



    B355336
  1. Detach the 3 hooks and disconnect the hood lock control lever from the lower instrument panel finish panel sub-assembly LH.



  1. Pull and slide the hood lock control cable, rotate the hood lock control cable, and then disconnect the hood lock control cable from the hood lock control lever.


    B355339



5. REMOVE NO. 2 SWITCH HOLE BASE


    B355343E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 4 clips and remove the No. 2 switch hole base.

  1. Disconnect each connector.



6. REMOVE VSC OFF SWITCH
  1. Disconnect the VSC OFF switch connector.



    C291835
  1. Using a screwdriver, detach the 2 claws and remove the VSC OFF switch from the No. 2 switch hole base.