Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the Techstream on.

  6. Enter the following menus: Body Electrical / (desired system) / Data List.

  7. According to the display on the Techstream, read the Data List.

    Master Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door P/W Auto SW
    Driver side power window auto UP/DOWN switch signal / ON or OFF
    ON: Driver side switch of master switch operated
    OFF: Driver side switch of master switch not operated
    -
    P Door P/W Auto SW
    Front passenger side power window remote auto UP/DOWN switch signal / ON or OFF
    ON: Front passenger side switch of master switch operated
    OFF: Front passenger side switch of master switch not operated
    -
    P Door P/W Up SW
    Front passenger side power window remote manual UP switch signal / ON or OFF
    ON: Front passenger side switch of master switch operated
    OFF: Front passenger side switch of master switch not operated
    -
    P Door P/W Down SW
    Front passenger side power window remote manual DOWN switch signal / ON or OFF
    ON: Front passenger side switch of master switch operated
    OFF: Front passenger side switch of master switch not operated
    -
    Window Lock Switch Status
    Power window LOCK switch / ON or OFF
    ON: Power window lock switch in LOCK position
    OFF: Power window lock switch in UNLOCK position
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    D-Door Motor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door P/W Auto SW
    Driver side power window auto UP/DOWN switch signal / ON or OFF
    ON: Driver side switch operated
    OFF: Driver side switch not operated
    -
    D Door P/W Up SW
    Driver side power window MANUAL UP switch signal / ON or OFF
    ON: Driver side switch operated
    OFF: Driver side switch not operated
    -
    D Door P/W Down SW
    Driver side power window MANUAL DOWN switch signal / ON or OFF
    ON: Driver side switch operated
    OFF: Driver side switch not operated
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    P-Door Motor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P Door P/W Auto SW
    Front passenger side power window auto UP/DOWN switch signal / ON or OFF
    ON: Power window regulator switch assembly operated
    OFF: Power window regulator switch assembly not operated
    -
    P Door P/W Up SW
    Front passenger side power window manual UP switch signal / ON or OFF
    ON: Power window regulator switch assembly operated
    OFF: Power window regulator switch assembly not operated
    -
    P Door P/W Down SW
    Front passenger side power window manual DOWN switch signal / ON or OFF
    ON: Power window regulator switch assembly operated
    OFF: Power window regulator switch assembly not operated
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy switch signal / ON or OFF
    ON: Driver door open
    OFF: Driver door closed
    -
    P Door Courtesy SW
    Front passenger side door courtesy switch signal / ON or OFF
    ON: Front passenger door open
    OFF: Front passenger door closed
    -
    Door Lock SW-Lock
    Driver side door lock switch signal / ON or OFF
    ON: Door control switch is pushed to lock position
    OFF: Door control switch is not pushed
    -
    Door Lock SW-Unlock
    Driver side door unlock switch signal / ON or OFF
    ON: Door control switch is pushed to unlock position
    OFF: Door control switch is not pushed
    -
    Door Key P/W Up
    Function to close the driver side door window while holding the key to the lock side for more than about 2.3 seconds / ON or OFF
    Customize setting displayed
    -
    Door Key P/W Down
    Function to open the driver side door window while holding the key to the unlock side for more than about 2.3 seconds / ON or OFF
    Customize setting displayed
    -
    Communication D-Door Motor
    Connection status between power window regulator motor (for driver side) and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection
    -
    Communication P-Door Motor
    Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection
    -
    Communication Master SW
    Connection status between master switch and main body ECU / OK or Stop
    OK: Connection
    Stop: No connection
    -
    Door Key SW-Lock
    Door key linked lock switch signal / ON or OFF
    ON: Driver side door key cylinder is turned to lock position
    OFF: Driver side door key cylinder is not turned
    -
    Door Key SW-Unlock
    Door key linked unlock switch signal / ON or OFF
    ON: Driver side door key cylinder is turned to unlock position
    OFF: Driver side door key cylinder is not turned
    -


PERFORM ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the Techstream on.

  6. Enter the following menus: Body Electrical / (desired system) / Active Test.

  7. According to the display on the Techstream, perform the Active Test.

    CAUTION:
    Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


    D-Door Motor 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power Window
    Driver side power window
    OFF/UP/DOWN
    -

    P-Door Motor 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power Window
    Front passenger side power window
    OFF/UP/DOWN
    -

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    IG OFF P/W Control Permission Output
    Power window control permission output
    ON or OFF
    -