Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
  1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL VVT SENSOR (for Intake Side of Bank 2)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



4. INSTALL VVT SENSOR (for Intake Side of Bank 1)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



5. INSTALL AIR CLEANER HOSE ASSEMBLY


    A238100E01
  1. Install the air cleaner hose with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

    Text in Illustration 
    *1
    Paint Mark
    *a
    Protrusion
    *b
    Groove
    *c
    Top
    *d
    RH
    *e
    Front

  1. Connect the vacuum hose and ventilation hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Attach the wire harness clamp.



6. INSTALL NO. 2 EMISSION CONTROL VALVE SET
(Click here)