Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


C158582E02
  1. Place matchmarks on the propeller shaft flange and differential flange.
    Text in Illustration 
    *a
    Matchmark

  1. Remove the 4 bolts and 4 nuts. Then disconnect the propeller shaft from the differential side.



    C158583
  1. w/o Bearing Washer:
    Remove the 2 mounting bolts from the crossmember.

  1. w/ Bearing Washer:
    Remove the 2 mounting bolts and 2 bearing washers from the crossmember.

  1. Remove the propeller shaft.



    C164127E06
  1. for 1GR-FE and 1UR-FE:
    Insert SST into the transmission to prevent oil leakage.

    SST
    09325-40010  
    Text in Illustration 
    *A
    for 1GR-FE and 1UR-FE



    C160071E03
  1. for 3UR-FE:
    Insert SST into the transmission to prevent oil leakage.

    SST
    09325-60010  
    Text in Illustration 
    *A
    for 3UR-FE