EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK PURGE VSV |
Connect the Techstream to the DLC3.
![]() |
Disconnect the hose (connected to the charcoal canister) from the purge VSV.
Start the engine and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for EVAP Control.
| Tester Operation | Specified Condition |
| EVAP VSV: OFF | Purge VSV has no suction |
| EVAP VSV: ON | Purge VSV has suction |
Connect the hose (connected to the charcoal canister) to the purge VSV.
| 2. INSPECT FUEL CUT-OFF RPM |
Start and warm up the engine.
Increase the engine speed to at least 3500 rpm.
Use a sound scope to check for injector operation noise.
Check that when the accelerator pedal is released, injector operation noise stops momentarily, and then resumes.
If the result is not as specified, check the injector, wiring and ECM.
| 3. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
Check that there are no cracks, leaks or damage.
| 4. INSPECT FUEL CUT OFF VALVE AND FILL CHECK VALVE |
Disconnect the vent line hose from the charcoal canister.

| *1 | Fuel Tank Cap | *2 | Charcoal Canister |
| *3 | Vent Line Hose | - | - |
Connect a pressure gauge to the vent line hose.
Fill the fuel tank with fuel.
Apply a pressure of 4 kPa (41 gf/cm2, 0.6 psi) to the vent port of the fuel tank.
Remove the fuel tank cap and check that the pressure inside the tank drops.
If the pressure does not drop, replace the fuel tank assembly.
Reconnect the vent line hose to the charcoal canister.
| 5. CHECK AIR INLET LINE |
![]() |
Disconnect the air inlet line hose from the charcoal canister.
Check that there is ventilation in the air inlet line.
If air cannot flow freely into the air inlet line, repair or replace the air inlet line.
Reconnect the air inlet line hose to the charcoal canister.
| 6. INSPECT SECONDARY AIR INJECTION SYSTEM OPERATION |
Start the engine and warm it up.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Air Injection Check / Manual Mode / AIR PUMP: ON, ASV1: OPEN, ASV2: OPEN and AIR PUMP: OFF, ASV1: CLOSE, ASV2: CLOSE.
Start the engine.
Perform the secondary air injection system forced operation while the engine is idling.
Check that the status of the air pump (AIR PUMP), ASV and pressure in the secondary air injection system passage (PRESSURE) displayed on the Techstream matches the conditions shown in the table below.
| Tester Operation | Air Pump | Air Switching Valve | Pressure*1 | Pulsation*2 |
| AIR PUMP: ON, ASV: OPEN | ON | OPEN | 1 kPa or higher | 15 kPa or higher |
| AIR PUMP: OFF, ASV: CLOSE | OFF | CLOSE | Below 3 kPa | Below 25 kPa |
Turn the ignition switch off.