TIRE AND WHEEL SYSTEM > INSPECTION |
| 1. INSPECT TIRE |
Check the tires for wear and proper inflation pressure.
| Tire size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P255/70R18 | 210 (2.1, 30) | 230 (2.3, 33) |
| P275/65R18 | ||
| P275/55R20 | ||
| P255/70R18 (Spare Tire) | 230 (2.3, 33) | |
![]() |
Using a dial indicator, check the tire runout.
| 2. ROTATE TIRE |
![]() |
Rotate the tires as shown in the illustration.
| *a | Front of the Vehicle |
| 3. INSPECT WHEEL BALANCE |
![]() |
for Steel Wheel Type:
Check and adjust the off-the-car balance.
![]() |
for Aluminum Wheel Type:
Check and adjust the off-the-car balance.
| 4. INSPECT FRONT AXLE HUB |
| 5. INSPECT REAR AXLE SHAFT |