Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)


2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A224775E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A224777
  1. Remove the 8 bolts, rear spacer, drive plate and front spacer.



3. REMOVE REAR CRANKSHAFT OIL SEAL


    A076328E03
  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or crankshaft.