Home › ENGINE ยท 1UR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here


HINT:
If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    A215892E01

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE AIR CLEANER ASSEMBLY


    A272399E01
  1. Detach the clamp and disconnect the mass air flow meter connector.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner assembly.



5. REMOVE AIR TUBE SUB-ASSEMBLY LH


    A215879
  1. Disconnect the 2 connectors.

  1. Disconnect the water by-pass hose.



    A215282
  1. Disconnect the 2 wire harness clamps and air hose.

  1. Remove the bolt and disconnect the air tube LH from the water inlet housing.



    A215284
  1. Disconnect the vacuum sensor connector and clamp.

  1. Remove the 2 bolts and disconnect the air hose from the air switching valve LH.

  1. Remove the air tube LH.



6. DISCONNECT OUTLET RADIATOR HOSE


    A215882
  1. Disconnect the radiator hose.



7. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT


    A215881
  1. Remove the 3 nuts, water inlet with thermostat and gasket.