Home › ENGINE ยท 1GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.


    A237558E01


    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Radiator Cap
    *3
    Radiator Drain Cook Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.



2. DISCONNECT RADIATOR HOSE OUTLET


    A238109
  1. Disconnect the radiator hose outlet.



3. REMOVE WATER INLET WITH THERMOSTAT

HINT:
If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.



    A223010
  1. Remove the 3 nuts, water inlet with thermostat and gasket.