RADIATOR > REMOVAL |
| 1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 5. DISCONNECT INLET RADIATOR HOSE |
Slide the clip and disconnect the inlet radiator hose from the radiator assembly.
| 6. DISCONNECT OUTLET RADIATOR HOSE |
Slide the clip and disconnect the outlet radiator hose from the radiator assembly.
| 7. REMOVE FAN SHROUD |
![]() |
Loosen the 4 nuts holding the fan with fluid coupling.
Remove the fan and generator V-belt.
Disconnect the reservoir hose from the upper radiator tank.
![]() |
for Condenser with Integrated Oil Cooler:
Detach the claw and open the No. 1 flexible hose clamp.
![]() |
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fan with fluid coupling, and then remove the fan shroud together with the fan with fluid coupling.
Remove the fan pulley from the fan bracket.
| 8. DISCONNECT RADIATOR SIDE DEFLECTOR RH |
![]() |
Using a clip remover, remove the 3 clips to disconnect the radiator side deflector RH.
| *a | except Condenser with Integrated Oil Cooler |
| *b | for Condenser with Integrated Oil Cooler |
| 9. DISCONNECT RADIATOR SIDE DEFLECTOR LH |
![]() |
Using a clip remover, remove the 3 clips to disconnect the radiator side deflector LH.
| 10. REMOVE RADIATOR ASSEMBLY |
![]() |
Remove the 4 bolts and radiator assembly.