Home › ENGINE ยท 1UR-FE › CHARGING › GENERATOR

GENERATOR > INSTALLATION

for Preparation Click here



1. INSTALL GENERATOR ASSEMBLY


    A216790
  1. Install the generator with the 3 bolts and nut.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



    A215539
  1. Install the harness bracket to the generator with the bolt.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }

  1. Connect the generator connector.

  1. Connect the generator wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.



2. CONNECT VANE PUMP ASSEMBLY


A163333E05
  1. Connect the vane pump assembly to the timing chain cover sub-assembly with the 2 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

    Text in Illustration 
    *a
    Spacer

    HINT:
    Before performing the following procedures, move the spacer until the vane pump assembly can be installed.



3. CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


    C161010
  1. Connect the power steering oil pressure sensor connector.



4. INSTALL FRONT FENDER APRON SEAL RH
  1. Install the fender apron seal with the 6 clips.



5. INSTALL AIR CLEANER ASSEMBLY
  1. Install the air cleaner assembly with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Tighten the hose clamp.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the ventilation hose and vacuum hose.

  1. Attach the clamp and connect the mass air flow meter connector.



6. INSTALL FAN AND GENERATOR V BELT
  1. Install the fan and generator V belt (Click here).



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL