Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH
  1. Remove the front shock absorber with coil spring .



3. DISCONNECT SKID CONTROL SENSOR WIRE


C155974E01
  1. Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm.



4. DISCONNECT STEERING KNUCKLE LH
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and the nut.



    C155977E01
  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  



5. REMOVE FRONT FENDER APRON SEAL LH


C155975
  1. Using a clip remover, remove the 6 clips and apron seal.



6. REMOVE FRONT FENDER APRON SEAL REAR LH


C159163
  1. Using a clip remover, remove the 5 clips and apron seal.



7. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY


C155976
  1. Remove the nut, bolt, 2 washers and suspension upper arm.